Product Overview. The Everbilt 3 in. Non-Mortise Hinges (2-Pack) features a five knuckle full mortise design. The removable pin provides easier installation or removal of door. Easy to install. The Everbilt 3 in. Non-Mortise Hinges (2-Pack) features a five knuckle full mortise design. The removable pin provides easier installation.
With beefy hinge leaves designed to fit shutter panel thicknesses of 1' to 1-1/16', these are the ideal hinges for your thick, custom window shutters. The hinges feature a removable pin, making it easy to remove your shutters or doors for cleaning or refinishing.
Removable pin also allows reversal as needed for right-hand or left-hand applications. The 3' No-Mortise Butt Hinges make ideal shutter hinges, but are also well-suited for kitchen cabinet doors. Interlocking hinge leaves eliminate the need to cut hinge mortises. Didn't really shop too much for my plantation shutter hinges, so my review isn't comprehensive by any means. I decided to splurge a bit instead of buying cheaper ones. Have installed several now as part of an ongoing shutter build and install process. There's zero adjustment to the hinge per-se, so installation must be as dead-on as possible.
Highly recommend a drill bit centering gizmo. For some reason, there are a multitude of screws included with each hinge pak. 
Nice finish, carefully packaged. Seems a good buy if a person doesn't want bargain-basement value.
The hinges are exactly what I needed and worked well for my application. When I reinstall the hinges after painting I'm going to need to replace all the screws since the heads on a large percentage of them stripped out on the initial installation. A note on the service I received in the Portland, Maine store: the gentleman who assisted me was great, turns out the size hinges I needed was being pulled from their retail outlets and going to catalog sales only. He had to dig through a couple of large tote bins filled with a couple of hundred assorted hinges and managed to find enough to fill my requirements. It would have been a lot quicker and less effort on his part to just refer me to the catalog. Another plus was that once we had the pile of the correct size hinges I needed, they were on sale for 60% off and saved me about $30. Vs retail price in the catalog.
Very satisfied store customer. I used these hinges on an entertainment center with three inset glass doors. This is my first experience building and installing doors.
Two of the doors would not close completely until I removed the set screw in the edge of the door. One of the hinges was bent when it arrived and had to be worked on my anvil to get it flat. One door still does not close perfectly. May be my construction but I feel the bad hinge may be the problem. I guess I should have returned the bad hinge.
The wrap around section of the hinge for the door appeared to be less than 90 degrees which could have caused the problem with the door not closing. Quality control seemed to be lacking. BEST ANSWER: This type of hinge is designed for use with Typical 3/4' Face frames -- also can be used for 1/2' doors in smaller application. BEST ANSWER: This type of hinge is designed for use with Typical 3/4' Face frames -- also can be used for 1/2' doors in smaller application.